1. |
Operate the seat warmer after connecting the connector, and then
check the thermostat by measuring the temperature of seat surface.
|
2. |
Disconnect the connectors to check for continuity and measure
the resistance between terminals.
|
3. |
Measure the resistance between A1 and B1 terminals of seat cushion.
|
4. |
Measure the resistance between C1 and C2 terminals of seat back.
|
5. |
To measure the resistance of seat back and cushion, connect the
B and C connectors.
Measure the resistance between A1 and C1 terminals of seat.
|
1. |
Operate the seat warmer after connecting the connector, and then
check the thermostat by measuring the temperature of seat surface.
|
2. |
Measure the resistance between 1 and 3 terminals of seat cushion.
[Rear RH seat]
[Rear LH seat]
|
Front Stabilizer Bar Removel
1.
Remove the front wheel and tire (A) from front hub .
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
...
Cluster Ionizer Description
The cluster ionizer makes disinfection and decomposition of bad smell
from the air-conditioner or inflow air. And it cleans the inside air of a vehicle.
When the ignition switch is ON, the i ...
Installation
•
Install the component with the specified torques.
•
...