Kia Sorento: Seat Belt Buckle Switch (BS) Installation
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Restraint / SRSCM / Seat Belt Buckle Switch (BS) Installation
Be sure to install the harness wires not to be pinched or interfered
with other parts.
|
| 1. |
Remove the ignition key from the vehicle.
|
| 2. |
Disconnect the battery negative cable, and wait for at least three
minutes before beginning work.
|
| 3. |
Install the seatbelt buckle & buckle switch.
|
| 4. |
Install the front seat assembly. . (Refer to the Body group- Front
seat)
|
| 5. |
Reconnect the battery negative cable.
|
| 6. |
After installing the seat belt buckle switch, confirm proper system
operation:
|
Seat Belt Buckle Switch (BS) Removal
1.
Disconnect the battery negative cable, and wait for at least three
minutes before beginning work.
2.
Remove the front seat assembly. (Re ...
Occupant Detection system (ODS) Description
In order to make normal activation of airbag system, SRSCM detects DTC(s)
for the Passenger side Body Detection System. If the seat is occupied, Body
sensor detects how measuring electrostati ...
See also:
Front Oil Seal Removal and Installation
1.
Remove the crankshaft damper pulley.
(Refer to Timing System - "Crankshaft Damper Pullty")
2.
Remove the front oil seal(A). ...
Flex Steering Components Location
1. Flex steering switch
...
Description
BSD is a system that uses two magnetic wave radar sensors attached on
the rear bumper to measure the distance from the following vehicles and provides
the sensing and (visual and auditory) al ...
Copyright В© www.ksmanual.com 2014-2024