1. |
Remove the air duct.
(Refer to Engine Mechanical System - "Air cleaner")
|
2. |
Remove the battery and the battery tray.
(Refer to Engine Electrical System - "Battery")
|
3. |
Remove the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
|
4. |
Drain the coolant.
(Refer to Engine Mechanical System - "Coolant")
|
5. |
Remove the drain plug (A) and reinstall the drain plug after draining
ATF totally.
|
6. |
Remove the wiring bracket installation bolt (A).
|
7. |
Remove the ATF Injection hole(eyebolt) (A).
|
8. |
Disconnect the coolant hose (B) after removing the coolant hose
clamp (A).
|
9. |
Disconnect the hose (B) after removing the automatic transaxle
fluid cooler hose clamp (A).
|
10. |
Remove the valve body cover (A).
|
11. |
Remove the bolts (C) after disconnecting the solenoid valve connector
(B) and the oil temperature sensor connector (A).
|
12. |
Remove the solenoid valve support bracket (B) and the valve body
mounting bolt (A-1ea).
|
13. |
Remove the torque converter control solenoid valve (A).
|
Windshield Wiper-Washer Switch Inspection
Check for continuity between the terminals while operating the wiper and
washer switch. If it is not normal condition, replace wiper and wiper switch.
Wiper Switch
Washer Switch
R ...
Warning Messages
Shift to "P" position (for smart key system and automatic transaxle)
This warning message illuminates if you try to turn off the engine without
the shift lever in P (Park) position.
...
Side Impact Sensor (SIS) Installation
Front Side Impact Sensor
•
Do not turn the ignition switch ON and do not connect ...