1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Lift the vehicle.
|
3. |
Disconnect the canister close valve connector (A).
|
4. |
Disconnect the ventilation tube quick-connector (B) from the fuel
tank air filter and canister close valve.
|
5. |
Disconnect the vapor tube quick-connector (A).
|
6. |
Remove the canister assembly bracket (D) after removing the mounting
bolts (B) and nut (C).
|
7. |
Remove the canister braket (B) installation bolt (A).
|
8. |
Remove the fuel tank air filter & canister close valve assembly
(A) after rotating it in the direction of the arrow in the figure.
|
9. |
Release the lever (A), and then separate the canister close valve
(B) from the fuel tank air filter (C) after rotating it in the direction
of the arrow in the figure.
|
Input Speed Sensor Circuit Diagram
...
Curtain Airbag (CAB) Module Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least thirty
seconds.
...
Blower Unit Components
1. Intake Case (LH)
2. Intake Case (RH)
3. Intake Door
4. Cowl Seal
5. NVH Seal
6. Blower Upper Case
7. Cluster Ionizer
8. Blower Lower Case
9. Power Mosfet (DAT ...