Kia Sorento: Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Remove the rear seat.
(Refer to Body - "Rear Seat Assembly")
|
| 3. |
Remove the fuel pump service cover (A) in the trunk.
|
| 4. |
Disconnect the fuel tank pressure sensor connector (A), and then
remove the fuel tank pressure sensor.
|
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the FTPS.
Specification:
...
Installation
•
Install the component with the specified torques.
•
...
See also:
Circuit Diagram
...
Driver Airbag (DAB) Module and Clock Spring Inspection
Driver Airbag (DAB)
If any improper parts are found during the following inspection, replace
the airbag module with a new one.
...
Variable Intake Solenoid (VIS) Valve
Variable Intake manifold Solenoid (VIS) valve is installed on the intake
manifold. The VIS valve controls the vacuum modulator which activates a valve
in the intake manifold. The ECM opens or ...
Copyright © www.ksmanual.com 2014-2024