Kia Sorento: Removal
| 1. |
Turn the ignition switch OFF and disconnect the negative (-) battery
cable.
|
| 2. |
Disconnect the accelerator position sensor connector (A).
|
| 3. |
Remove the installation nuts (C), the bolt (B) and then remove
the accelerator pedal module.
|
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the output volt ...
Installation
1.
Install in the reverse order of removal.
Accelerator pedal module installation
nut:
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18 ...
See also:
Interior lights
CAUTION
Do not use the interior lights for extended periods when the engine is not
running. It may cause battery discharge.
WARNING
Do not use the interior lights when driving in the dark. Acciden ...
Telemetics Unit (TMU) Removal
•
Take care not to scratch the crash pad and related parts.
...
Master Cylinder Components
1. Reservoir cap
2. Reservoir
3. Grommet
4. Master cylinder
...
Copyright В© www.ksmanual.com 2014-2024