1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Remove the intake manifold.
(Refer to Engine Mechanical System - "Intake Manifold")
|
3. |
Disconnect the injector connector (A).
|
4. |
Remove the installation bolt (B), and then remove the sensor from
the cylinder block.
|
IMS Control Switch Inspection
1.
Disconnect the IMS control switch connector.
2.
With the power IMS control switch in each position, make sure
that continuity ex ...
Components Location
1. AVN (A/V & Navigation) head unit
2. Tweeter speaker
3. External amplifier
4. Roof antenna (Radio+Sirius+GPS)
5. Front door speaker
6. Rear door speaker
7. Subwo ...
Inspection
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the fuel pressure regulator valve connector.
...