Kia Sorento: Removal
|
| [Bank 1 / Intake] |
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the camshaft position sensor connector (A).
|
| 3. |
Remove the installation bolt (B), and then remove the sensor.
|
| [Bank 1 / Exhaust] |
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the camshaft position sensor connector (A).
|
| 3. |
Remove the hanger and the protector.
|
| 4. |
Remove the installation bolt (B), and then remove the sensor.
|
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification:
Refer to “Wave Form”
...
Installation
•
Install the component with the specified torques.
•
...
See also:
Keep your vehicle clean
The best way to prevent corrosion is to keep your vehicle clean and free of corrosive
materials. Attention to the underside of the vehicle is particularly important.
If you live in a high-corrosi ...
Rear combination lamp Installation
1.
Install the tailgate combination lamp assembly after replacing
the bulb.
2.
Install the lamp cover to the tailgate after connecting the ...
Description
Evaporative Emission Control System prevents fuel vapor stored in fuel
tank from vaporizing into the atmosphere. When the fuel evaporates in the fuel
tank, the vapor passes through vent hoses ...
Copyright © www.ksmanual.com 2014-2024