Kia Sorento: Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the crankshaft position sensor connector (A).
|
| 3. |
Remove the protector (A).
|
| 4. |
Remove the installation bolt (A), and then remove the crankshaft
position sensor.
|
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification:
Refer to “Wave Form”
...
Installation
•
Install the component with the specified torques.
•
...
See also:
IMS Control Switch Inspection
1.
Disconnect the IMS control switch connector.
2.
With the power IMS control switch in each position, make sure
that continuity ex ...
Circuit Diagram
...
Inspection
1.
Turn ignition switch OFF.
2.
Remove the air duct.
(Refer to Engine Mechanical System - "Air cleaner")
...
Copyright © www.ksmanual.com 2014-2024