Whenever the high pressure fuel pump, fuel pipe, delivery pipe,
or injector is removed immediately after shutting off the engine, an
injury may be caused by the release of highly pressurized fuel. Release
the residual pressure in the high pressure fuel line by referring to
the "Residual fuel pressure release procedure" below before removing
any high pressure fuel system components.
|
Wear safety glasses and fuel resistant gloves.
|
1. |
Turn the ignition off and disconnect the battery negative cable.
|
2. |
Remove the fuel pump fuse (A).
|
3. |
Disconnect the electrical connector from the high pressure fuel
pump.
|
4. |
Reconnect the battery negative cable.
|
5. |
Run the engine for about 20 seconds to lower the pressure in both
the high or low pressurelines. The engine may shut off within the 20
second period. If not, turn the engine off.
|
6. |
Proceed with the service or repair. Use rags to cover opening
and catch spills when opening up the high pressure system.
|
7. |
Reinstall / re-connect all components in reverse order of removal.
Start engine and confirm proper operation, and make sure there are no
fuel leaks.
|
8. |
After completing, clear DTC(s) using GDS scan tool (the procedure
described above will cause DTC to set).
|
Transfer Fluid Replacement
Change
Normal Use
Severe Use
No service required
...
3. TCM Terminal input/ output signal
Connector [A]
Pin No.
Signal
Condition
Type
Level
29
Sports mode up switch
Up ON
Input
0V/Battery voltage level
...
Cruise Control Switch Removal
1.
Disconnect the battery (-) terminal.
2.
Remove the air-bag module from the steering wheel. ( Refer to
RT group)
3.
...