Kia Sorento: Rear Wiper Motor Removal
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Body Electrical System / Rear Wiper/Washer / Rear Wiper Motor Removal
| 1. |
Detach the rear wiper cap (A).
|
| 2. |
Remove the rear wiper arm & blade (A) after removing rear wiper
HEX nut (B).
|
| 3. |
Open the tailgate then remove the tailgate trim.
(Refer to Body - "Tailgate")
|
| 4. |
Disconnect the rear wiper motor connector (B) then remove the
rear wiper motor (A) after loosening bolts (3EA).
|
Rear Wiper Motor Inspection
Rear Wiper Motor
1.
Remove the 4P connector from the rear wiper motor.
2.
Connect battery positive (+) and negative (-) cables to terminals ...
Rear Wiper Motor Installation
1.
Install the rear wiper motor assembly.
Tightening torque Nut :
7 ~ 11 N.m (0.7 ~ 1.1 kgf.m, 5 ~ 7.9 lbf-ft)
...
See also:
Record your key number
The key code number is stamped on the bar code tag attached
to the key set. Should you lose your keys,
this number will enable an authorized Kia dealer to duplicate the keys easily.
Remove the ba ...
Rear combination lamp Installation
1.
Install the tailgate combination lamp assembly after replacing
the bulb.
2.
Install the lamp cover to the tailgate after connecting the ...
Blade inspection
✽ NOTICE
Commercial hot waxes applied by automatic vehicle washes have been known to
make the windshield difficult to clean.
Contamination of either the windshield or the wiper blades with ...
Copyright В© www.ksmanual.com 2014-2024