1. |
Remove the 4P connector from the rear wiper motor.
|
2. |
Connect battery positive (+) and negative (-) cables to terminals
3 and 4 respectively.
|
3. |
Check that the motor operates normally. Replace the motor if it
operates abnormally.
1. IGN +
2. Parking
3. Switch
4. Ground
|
1. |
Operate the motor at low speed using the stalk control.
|
2. |
Stop the motor operation anywhere except at the off position by
disconnecting terminal 3.
|
3. |
Connect terminals 2 and 3.
|
4. |
Connect the positive (+) lead from the battery to terminal 1 and
the negative (-) lead to terminal 4.
|
5. |
Check that the motor stops running at the off position.
|
Power brakes
Your vehicle has power-assisted brakes that adjust automatically through normal
usage.
In the event that the power-assisted brakes lose power because of a stalled engine
or some other reason, you c ...
Instrument Cluster Inspection
1.
Check the suspected area as below table when the warning light
is error.
NO
Warning light
Description
Communicatio ...
Specification
Temperature
Resistance (kΩ)
°C
°F
-40
-40
40.93 ~ 48.35
-20
-4
13.89 ~ 16.03
0
32
...