1. |
With the washer motor connected to the reservoir tank, fill the
reservoir tank with water.
|
2. |
Remove the front bumper cover.
(Refer to Body - "Front bumper")
|
3. |
Connect positive (+) and negative (-) battery cables to terminals
3 and 2 respectively to see that the washer motor runs and water is
pumped.
|
4. |
Check that the motor operates normally.
Replace the motor if it operates abnormally.
[Front & Rear washer]
1. Windshield washer (+)
2. Ground
3. Rear washer (+)
|
Rear Blower Resister Inspection
1.
Measure terminal-to-terminal resistance of the blower resistor.
2.
If the measured resistance is not within specification, the blower
re ...
Compressor Components
1. Center Bolt
2. Hub Bolt
3. Hub Assembly
4. Snap Ring
5. Pulley
6. Compressor Assembly
7. Electric Control Valve
...
Brake Line Installation
1.
Installation is the reverse of removal.
Use a new washer (A) whenever ...