1. |
Remove the rear wheel and tire (A) from rear hub .
|
2. |
In the case of 4WD vehicle, remove the rear differential assembly.
(Refer to Driveshaft and axle - "Rear Differential Carrier")
|
3. |
Loosen the nut (A-1ea) and then remove the rear stabilizer link
(B).
[2WD]
[4WD]
|
4. |
Loosen the bolt and then remove the rear stabilizer bar (A) with
the sub frame.
[2WD]
[4WD]
|
5. |
Installation is the reverse of removal.
|
Tilt and telescopic steering
Tilt and telescopic steering allows you to adjust the steering wheel before you
drive.You can also raise it to give your legs more room when you exit and enter
the vehicle.
The steering wheel shoul ...
Ignition Coil Inspection
1.
Measure the primary coil resistance between terminals (+) and
(-).
Standard value:
0.62Ω В± 10%
...
Special Service Tools
Tools
(Number and name)
Illustration
Use
09431-45100
Oil seal installer
Installation of transfer case oil seal.
(Right side)
...