1. |
Remove the rear wheel and tire (A) from rear hub.
|
2. |
Remove the coking nut (A).
|
3. |
Remove the rear shock absorber.
(Refer to Suspension System - "Rear Shock Absorber")
|
4. |
Remove the parking brake cable.
(Refer to Brake System - "Parking Brake Cable")
|
5. |
Remove the rear upper arm (A) after loosen the bolt (B).
|
6. |
Remove the rear lower arm (B), spring (C) as loosening bolt (A)
after supporting rear lower arm (B) with jack.
|
7. |
Remove the rear assist arm (C), trailing arm (D) as loosening
bolt (A), nut (B).
|
8. |
Separate the end (B) of rear driveshaft on rear axle assembly
(A).
|
9. |
Insert a pry bar (A) between the differential case (B) and joint
case (C), and separate the driveshaft (D) from the differential case.
|
10. |
Install in the reverse order of removal.
|
11. |
Check the wheel alignment.
(Refer to Suspension System - "Alignment")
|
Balance Shaft & Oil Pump Removal
BSM (Balance Shaft Module) Chain System
1.
Remove the timing chain.
(Refer to Timing System in this group)
2.
Install a stopper pin (A) ...
Rear Oil Seal Removal
1.
Remove the automatic transaxle.
(Refer to Automatic Transaxle System - "Automatic Transaxle")
2.
Remove the drive plate.
...
Curtain air bag
Curtain air bags are located along both sides of the roof rails above the front
and rear doors.
They are designed to help protect occupants in certain side impacts and to help
prevent them from e ...