1. |
Wrap tape around the driveshaft splines (TJ side ) to prevent
damage to the boots.
|
2. |
Apply grease to the driveshaft and install the boots.
|
3. |
Apply the specified grease to the inner race (A) and cage (B).
Install the cage (B) so that it is offset on the race as shown.
|
4. |
Apply the specified grease to the cage and fit the balls into
the cage.
|
5. |
Position the chamfered side (A) as shown in the illustration.
Install the inner race on the driveshaft(B), and then the snap ring.
|
6. |
Apply the specified grease to the outer race and install the BJ
outer race onto the driveshaft.
|
7. |
Apply the specified grease into the TJ boot and install the boot
with a clip.
|
8. |
Tighten the TJ boot bands.
|
9. |
Add the specified grease to the BJ as much as wiped away at inspection.
|
10. |
Install the boots.
|
11. |
Tighten the BJ boot bands.
|
12. |
To control the air in the TJ boot, keep the specified distance
between the boot bands when they are tightened.
|
CVVT Oil Control Valve (OCV)
Continuous Variable Valve Timing (CVVT) system advances or retards the
valve timing of the intake and exhaust valve in accordance with the ECM control
signal which is calculated by the engine ...
High Pressure Fuel Pump Removal
In case of removing the high pressure fuel pump, high pressure
fuel pipe, delivery pipe, and injector, there may be inju ...
Power Window Switch Inspection
Main Power Window Switch Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door trim and power window switch.
...