Kia Sorento: Rear Driveshaft Inspection

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Driveshaft and axle / Rear Driveshaft Assembly / Rear Driveshaft Inspection

1.	Check the driveshaft boots for damage and deterioration.

2.	Check the ball joint for wear and damage.

3.	Check the splines for wear and damage.

4.	Check the driveshaft for cracks and wears.

5.	Check the TJ outer race, inner race, cage and balls for rust or damage.

6.

Check for water, foreign matter, or rust in the BJ boot.

When the BJ assembly (A) is to be reused, do not wipe away the grease.

Check that there are no foreign substances in the grease. If necessary, clean the BJ assembly (A) and replace grease.

Rear Driveshaft Removal and Installation

1. Remove the rear wheel and tire (A) from rear hub. Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) ...

Rear Driveshaft Disassembly

• Do not disassemble the BJ assembly. • ...

See also:

Checking the engine oil level
1. Be sure the vehicle is on level ground. 2. Start the engine and allow it to reach normal operating temperature. 3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil ...

In-car Sensor (DATC only) Description
An in-car air temperature sensor is located in the crash pad lower panel. The sensor contains a thermistor which measures the temperature of the inside. The signal decided by the resistance ...

Towing
If the vehicle needs to be towed, call a professional towing service. Never tow vehicle with just a rope or chain. It is very dangerous.[Front] [Rear] Emergency Towing There are three popul ...

Categories

Copyright © www.ksmanual.com 2014-2024