1. |
Remove the rear wheel and tire (A) from rear hub.
|
2. |
Loosen the drain plug (A) and pull out the differential gear oil.
|
3. |
Remove the rear driveshaft.
(Refer to Rear Driveshaft Assembly - "Rear DriveShaft")
|
4. |
Remove the propeller shaft.
(Refer to Propeller Shaft Assembly - "Propeller Shaft")
|
5. |
Remove cover (B) as loosen screw (A-4ea).
|
6. |
Disconnect the pressure sensor connector (A) and oil hydraulic
motor connector (B).
|
7. |
Remove rear differential assembly (B) as loosen mounting (A-4ea)
after install jack.
|
8. |
After loosen the bolt and then remove the differential carrier
(B) from the coupling (A).
|
9. |
Install in the reverse order of removal.
|
10. |
Gear oil is injected.
|
11. |
Check the wheel alignment.
(Refer to Suspension System - "Alignment")
|
Parking Assist Sensor Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear bumper cover.
(Refer to Body - "Rear Bumper Cover")
...
Seat Belt Buckle Switch (BS) Installation
Be sure to install the harness wires not to be pinched or interfered
with other parts.
1.
...