1. |
Disconnect the negative (-) battery terminal.
[Outside]
|
2. |
Loose the screws (2EA) holding the rear combination lamp then
disconnect the connector (A) then remove the outside rear combination
lamp (B).
|
3. |
Replace the bulbs (B) after removing the rear combination lamp
assembly (A).
[Inside]
|
4. |
If the bulbs should be only replaced without removing lamp assembly,
replace the bulbs after removing the rear combination lamp cover inside
trunk.
|
5. |
Remove the tail gate service covers (A) when removing the inside
rear combination lamp assembly.
|
6. |
Disconnect the lamp cover on tailgate. Remove the lamp assembly
(A) after loosening nuts (3EA) and disconnecting the connector.
|
7. |
Remove the tailgate combination lamp assembly (A) and then replace
the bulbs (B).
|
8. |
If the bulbs should be only replaced without removing lamp assembly,
replace the bulbs after removing the tailgate lamp cover inside trunk.
|
Rear Lower Arm Removal
1.
Remove the rear wheel and tire (A) from rear hub .
Tightening torque :
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
...
Condenser Replacement
1.
Recover the refrigerant with a recovery/recycling/charging station.
2.
Disconnect the negative (-) battery terminal.
3.
...
Rear Hub - Carrier Inspection
1.
Check the hub for cracks and the splines for wear.
2.
Check the rear axle carrier for cracks.
...