Kia Sorento: Rear Blower Resister Replacement
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Heating,Ventilation And Air Conditioning / Rear Air Conditioner / Rear Blower Resister Replacement
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the rear luggage side trim.
(Refer to Body - "Interior Trim")
|
| 3. |
Remove the rear blower resistor (A) after loosening the mounting
screws.
|
| 4. |
Install in the reverse order of removal.
|
Rear Blower Resister Inspection
1.
Measure terminal-to-terminal resistance of the blower resistor.
2.
If the measured resistance is not within specification, the blower
re ...
Controller
...
See also:
Windshield Deicer Switch Installation
1.
Install the heater control unit.
2.
Install the center fascia panel.
...
Installation
•
Note that internal damage may occur when the component
is dropped. If the component ...
For safe All-wheel drive operation
WARNING - Four-wheel driving
The conditions of on-road or off-road that demand fourwheel drive mean all
functions of your vehicle are exposed to extreme stress than under normal road conditions.
Sl ...
Copyright В© www.ksmanual.com 2014-2024