Kia Sorento: Rail Pressure Sensor (RPS)

Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in the sensor converts the pressure to voltage signal. By using this signal, the ECM can control correct injection amount and timing and adjusts the fuel pressure with the fuel pressure regulator valve if the target pressure and the actual pressure calculated by the RPS output signal are different.

Installation

   • Install the component with the specified torques. • ...

Specification

...

See also:

Smart Key
Smart Key Code Saving 1. Connect the DLC cable of GDS to the data link connector (16 pins) in driver side crash pad lower panel, turn the power on GDS. ...

Compressor Description
The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of the engine. The compressor changes low pressure and low temperatur ...

ESC Operation Mode
ESC Hydraulic System Diagram 1. ESC Non-operation : Normal braking. Solenoid valve Continuity Valve Motor ...