1. |
Remove (-) negative battery terminal.
|
2. |
Remove the front door trim.
(Refer to Body - "Front door")
|
3. |
Disconnect the connector from the motor.
(A : Safety, B : Standard)
|
4. |
Connect the terminal No. 2 and No. 3 to battery voltage (12V)
and check that the motor operates smoothly when connecting the terminals
below.
|
5. |
Connect the motor terminals directly to battery voltage (12V)
and check that the motor operates smoothly. Next, reverse the polarity
and check that the motor operates smoothly in the reverse direction.
If the operation is abnormal, replace the motor.
|
1. |
Remove (-) negative battery terminal.
|
2. |
Remove the rear door trim.
(Refer to Body - "Rear door")
|
3. |
Disconnect the connector from the motor.
|
4. |
Connect the motor terminals directly to battery voltage (12V)
and check that the motor operates smoothly. Next, reverse the polarity
and check that the motor operates smoothly in the reverse direction.
If the operation is abnormal, replace the motor.
|
Front Stabilizer Bar Removel
1.
Remove the front wheel and tire (A) from front hub .
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
...
Heater & A/C Control Unit (DATC) Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remover, remove the center fascia panel
(A).
...
Sub Frame Removel
1.
Remove the front wheel and tire (A) from front hub .
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
...