Kia Sorento: Power Mosfet (DATC) Inspection
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Heating,Ventilation And Air Conditioning / Blower / Power Mosfet (DATC) Inspection
| 1. |
Measure the resistance between the terminals.
|
| 2. |
If the measured resistance is not within specification, the blower
resistor must be replaced. (After removing the resistor)
|
Blower Resistor Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the passenger side crash pad under cover (A).
3.
...
Power Mosfet (DATC) Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the passenger side crash pad under cover (A).
3.
...
See also:
Troubleshooting
1.
No windows operate from the main switch on the driver's door.
2.
Driver's side window does not operate.
...
Removal
1.
Remove the engine cover.
(Refer to Engine Mechanical System - "Engine cover")
2.
Remove the air cleaner assembly and air du ...
Side Body C
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
Front side m ...
Copyright В© www.ksmanual.com 2014-2024