Kia Sorento: Parking Brake Lever Assembly Removal
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Brake System / Parking Brake System / Parking Brake Lever Assembly Removal
The parking brake cables must not be bent or distorted. This will
lead to stiff operation and premature failure.
|
| 1. |
Remove the floor console assembly.
(Refer to Body - "Floor console")
|
| 2. |
Disconnect the connector (A) of parking brake switch.
|
| 3. |
Loosen the adjusting nut (A) and the parking brake cables (B).
|
| 4. |
Remove the parking brake lever assembly (A) after removing the
bolts.
|
Parking Brake Assembly Installation
Parking Brake Shoe
1.
Install the shoe hold down pin (A) and spring (B) by pressing
and rotating the spring.
2.
Install the ope ...
Parking Brake Lever Assembly Installation
1.
Install the parking brake lever assembly (A).
Tightening torque :
19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m, 14.5 ~ 21.7 lb-ft)
...
See also:
Fuel Filler Cap Description
A ratchet tightening device on the threaded fuel filler cap reduces the
chances of incorrect installation, which would seal the fuel filler. After the
gasket on the fuel filler cap and the fi ...
On-vehicle Inpection
•
First of all, check for DTCs. If a DTC is present, perform
troubleshooting in accord ...
Components and Components Location
Components (1)
1. Parking brake pedal
2. Equalizer assembly
3. Parking brake cable
Components (2)
1. Parking brake pedal assembly
2. Front parking brak ...
Copyright В© www.ksmanual.com 2014-2024