1. |
Install the parking brake lever assembly (A).
|
2. |
Install the parking brake cable (B) and tighten the adjusting
nut (A).
|
3. |
Apply a coating of the specified grease to each sliding parts
(A) of the ratchet plate or the ratchet pawl.
|
4. |
Install the parking brake cable adjuster, then adjust the parking
brake lever stroke by turning adjusting nut (A).
|
5. |
Release the parking brake lever fully, and check that parking
brakes do not drag when the rear wheels are turned. Readjust if necessary.
|
6. |
Make sure that the parking brakes are fully applied when the parking
brake lever is pulled up fully.
|
7. |
Reconnect the connector (A) of parking brake switch.
|
8. |
Install the floor console.
(Refer to Body - "Floor console")
|
Specifications
Description
Specifications
Limit
General
Type
In-line, DOHC
Number of cylinders
4
...
Rear Driveshaft Reassembly
1.
Wrap tape around the driveshaft splines (TJ side ) to prevent
damage to the boots.
2.
Apply grease to the driveshaft and install the boo ...
Failure Diagnosis
1.
In principle, ESC and TCS controls are prohibited in case of ABS
failure.
2.
When ESC or TCS fails, only the failed system control is pr ...