1. |
Remove the floor console.
(Refer to Body - "Floor console")
|
2. |
Apply the brake pedal 20 times with the force of 10kgf after bleeding.
Then, for the cable to settle in, apply the parking brake full stroke
more than 3 times.
|
3. |
Install the parking brake cable adjuster, then adjust the parking
brake lever stroke by turning adjusting nut (A).
|
4. |
Release the parking brake lever fully, and check that parking
brakes do not drag when the rear wheels are turned. Readjust if necessary.
|
5. |
Make sure that the parking brakes are fully applied when the parking
brake lever is pulled up fully.
|
6. |
Install the floor console.
(Refer to Body - "Floor console")
|
Vehicle handling instructions
As with other vehicles of this type, failure to operate this vehicle correctly
may result in loss of control, an accident or vehicle rollover.
Specific design characteristics (higher ground clearanc ...
Auto Defogging Actuator Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the cowl side trim.
(Refer to Body - "Crash Pad")
...
Driver Airbag (DAB) Module and Clock Spring Removal
1.
Set the front tires straight-ahead before removing the steering
wheel.
...