1. |
Install the shoe hold down pin (A) and spring (B) by pressing
and rotating the spring.
|
2. |
Install the operating lever assembly (D) and the upper return
spring (C).
|
3. |
Install the adjuster assembly (B) and the lower return spring
(A).
|
4. |
Install the hub assembly.
(Refer to Drive shaft and axle - "Rear hub - carrier")
|
5. |
Install the parking brake cable (B), and then install the fixing
clip (A).
|
6. |
Install the rear brake disc, then adjust the rear brake shoe clearance.
|
7. |
Install the brake caliper assembly.
(Refer to Brake system - "Rear disc brake")
|
8. |
Install the tire and wheel, after installing the plug on the disc.
|
9. |
If the parking brake shoe or the brake disc are replaced a newly
one, perform the brake shoe bed-in procedure.
|
Component Location
1. Power door mirror
2. Power door mirror
3. Power folding mirror switch
...
Valve Body
The valve body is essential to automatic transaxle control and consists
of various valves used to control the oil feed from the oil pump. Specifically,
these valves consist of pressure regula ...