1. |
Turn the ignition key to the ON position and then close the panoramaroof
completely.
|
2. |
Release the panoramaroof control lever.
|
3. |
Press and hold the CLOSE button for more than 10 seconds until
the sunroof has moved slightly.
|
4. |
Release the panoramaroof control lever.
|
5. |
Press and hold the CLOSE button once again within 5 seconds until
the panorama sunroof do as follows ;
|
6. |
Reset procedure of panorama system is finished.
|
1. |
The panoramaroof ECU detects the Run- time of motor
|
2. |
Motor can be operated continuously for the 1st Run-time(120 ±
10sec.).
|
3. |
Motor which is operated continuously stops operating after the
1st Run-time(120 ± 10sec.).
|
4. |
And then Motor is not operated for the 1st Cool-time(18 ± 2sec.).
|
5. |
Motor is operated for the 2nd Run-time(10 ± 2sec.) at the continued
motor operation after 1st Cool-time(18 ± 2sec.)
|
6. |
Motor which is operated continuously stops operating after the
2nd Run-time(10 ± 2sec.)
|
7. |
Motor is not operated for the 2nd Cool-time(18 ± 2sec.).
|
8. |
Motor repeats the 2nd Run-time and 2nd Cool-time at the continued
motor operation.
T1 : 120 ± 10 sec., T2 : 18 ± 2 sec.,
T3 : 10 ± 2 sec., T4 : 18 ± 2 sec.
|
ECM Terminal And Input/Output signal
ECM Terminal Function
Connector [C300-A]
Pin
No.
Description
Connected to
1
Ignition Coil (Cylinder #2) control output
[NON-smart ke ...
Description
An inverter is a device that transforms the DC voltage from the battery
into an AC voltage (115 V). The inverter can power various electrical devices
that consume 150 W or less, including mob ...
Windshield Deicer Switch Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the center fascia panel (A).
(Refer to Body - "Crash pad")
...