Kia Sorento: Oil Seal Replacement
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / 4 Wheel Drive (4WD) System / Transfer Assembly / Oil Seal Replacement
[Right side]
| 1. |
Remove the front muffler. (Only gasoline 3.3)
(Refer to Engine Mechanical System - "Front Muffler ")
|
| 2. |
Remove the driveshaft assembly. (RH side)
(Refer to Driveshaft and axle - "Front Driveshaft ")
|
| 3. |
Remove the dust cover (A).
|
| 4. |
Remove the oil seal (A, B).
|
| 5. |
Install the oil seal with special service tools.
|
| 6. |
Install the new dust cover (A).
|
| 7. |
Add to transfer fluid.
(Refer to 4 Wheel Drive System - "Transfer Fluid")
|
| 8. |
Install the drive shaft assembly. (RH side)
(Refer to Driveshaft and axle - "Front Driveshaft ")
|
| 9. |
Install the front muffler. (Only gasoline 3.3)
(Refer to Engine Mechanical System - "Front Muffler ")
|
[Left side]
| 1. |
Remove the transfer assembly from the transaxle assembly.
(Refer to Transfer Assembyl - "Front Wheel Transfer Assembly")
|
| 2. |
Remove the oil seal (A).
[Gasoline 2.4]
[Gasoline 3.3]
|
| 3. |
Install the oil seal with special service tools.
[Gasoline 2.4]
[Gasoline 3.3]
|
| 4. |
Add to transfer fluid.
(Refer to 4 Wheel Drive System - "Transfer Fluid")
|
| 5. |
Install the transfer assembly.
(Refer to 4 Wheel Drive System - "Front Wheel Transfer Assembly")
|
Front Wheel Transfer Assembly Installation
1.
Install in the reverse order of removal.
1.
...
See also:
Oil Pump Component
1. Reaction shaft support assembly
2. Oil pump housing
3. Driven gear
4. Drive gear
5. Oil seal
6. Bush-Housing
7. Reaction shaft
8. Bush- Reaction shaft
9. Sl ...
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the CVVT oil control valve connector (A).
...
Rear Cross Member Replacement
1.
Remove the rear wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
Copyright © www.ksmanual.com 2014-2024