1. |
Check the continuity between the terminal and the body with an ohmmeter.
If there is no continuity, replace the oil pressure switch.
|
2. |
Check the continuity between the terminal and the body when the fine
wire is pushed. If there is continuity even when the fine wire is pushed,
replace the switch.
|
3. |
If there is no continuity when a 50kPa (0.50kgf/cm², 7.25psi) is applied
through the oil hole, the switch is operaing properly.
Check for air leakage. If air leaks, the diaphragm is broken. Replace
it.
|
Underdrive Brake Control Solenoid Valve(UD/B_VFS)
Underdrive brake control solenoid valve(UD/B) is attached to the valve
body. This variable force solenoid valve directly controls the hydraulic pressure
inside the underdrive brake.
...
Engine Room Under Cover Components
1. Under Cover
2. Side Cover (RH)
3. Side Cover (LH)
...
Cylinder Block Reassembly
1.
Install the oil jet (A).
Tightening torque :
24.5 ~ 29.4 N.m (2.5 ~ 3.0 kgf.m, 18.1 ~ 21.7 lb-ft)
...