1. |
Remove the coupling assembly.
(Refer to Coupling Assembly - "Direct Electro Hydraulic Actuator
Coupling")
|
2. |
Keep going perpendicular state after remove the coupling assembly.
|
3. |
Remove the hydraulic motor (A) after loosening bolts with hex
wrench.
|
3. TCM Terminal input/ output signal
Connector [A]
Pin No.
Signal
Condition
Type
Level
29
Sports mode up switch
Up ON
Input
0V/Battery voltage level
...
Specification
Item
Resistance (Ω)
Driver Airbag (DAB)
1.6 ~ 6.0
Passenger Airbag (PAB)
1.6 ~ 6.0
Side Airbag (SAB)
1.6 ~ 6.0
...
Blind Spot Detection Unit Installation
1.
Install the BSD units to the rear bumper.
2.
Install the rear bumper.
3.
Connect the negative (-) battery te ...