Projected Dimensions |
1. |
These are the dimensions measured when the measurement points
are projected into the reference plane, and are the reference dimensions
used for body alterations.
|
2. |
If the length of the tracking gauge probes is adjustable, make
the measurement by lengthening one probe by the amount equivalent to
the difference in height of the two surfaces.
|
Actual-Measurement Dimensions |
1. |
These dimensions indicate the actual linear distance between measurement
points, and are the reference dimensions for use if a tracking gauge
is used for measurement.
|
2. |
Measure by first adjusting both probes to the same length (A=A').
|
Measurement Point |
1. |
Measurements should be taken at the hole center.
|
Specifications
▷ Type: Combination of output signals from 4 terminals
▷ Specifications
Power supply (V)
12
Output type
Pin to Pin
▷ Signal ...
External Amplifier Installation
External Amplifier
1.
Install the external amplifier after connecting the connector.
2.
Install the passenger seat assembly.
...
Circuit Diagram
...