1. |
Check that the shift lever is placed in the "N" position
|
2. |
Install the inhibitor switch (A).
|
3. |
Install the manual control lever (A).
|
4. |
Align the hole (A) in the manual control lever with the "N" position
hole (B) of the inhibitor switch and then insert the SST inhibitor switch
guide pin (09480-A3800).
|
5. |
Tighten the nut (A) and bolts (B) with the specified torque.
|
6. |
Remove the SST (09480-A3800) from the hole.
|
7. |
Connect the inhibitor switch connector (A).
|
8. |
Install the shift cable by tightening nut (A).
|
9. |
Push the shift cable to the arrow "F" to eliminate free play and
then tighten the nut (A) with the specified torque.
|
10. |
Install the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
|
11. |
Install the air cleaner assembly.
(Refer to Engine Mechanical System - "Air cleaner")
|
ATF Warmer Component Location
1. ATF Warmar
2. Bypass valve
3. ATF hose & pipe
4. Coolant hose & pipe
...
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification:
Refer to “Wave Form”
...
Sound settings
Press the
key
Select [Sound] through
TUNE knob or key
Select menu through
TUNE knob
Sound Settings
This menu allows you to set the ‘Bass, Middle, Treble’ and the Sound Fader ...