Kia Sorento: Installation
1. |
Install in the reverse order of removal.
If the oil seal on the transaxle case side is damaged
and fluid is leaking, replace the oil seal with a new unit.
When installing the new oil seal, use the specialized
tool.
2WD both side:
09453-3L240
4WD transaxle case side:
09453-3L240
4WD transaxle housing
side : 09453-2W100
|
|
After replacement or reinstallation procedure of the automatic
transaxle assembly, must perform procedures below.
• |
Adding automatic transaxle fluid.
(Refer to Hydraulic System - "Fluid")
|
• |
Adding coolant.
(Refer to Engine Mechanical System - "Coolant")
|
• |
After replacing the automatic transaxle, clear
the Diagnostic Trouble Code(DTC) using the GDS tool.
DTC cannot be cleared by disconnecting the battery.
|
• |
When replacing the automatic transaxle, reset
the automatic transaxle's values by using the GDS.
|
• |
Perform TCM learning after replacing the transaxle
to prevent slow transaxle response, jerky acceleration
and jerky startup.
(Refer to Automatic Transaxle Control System -
"Repair procedures")
|
|
|
1.
Remove the engine cover.
(Refer to Engine Mechanical System - "Engine cover")
2.
Remove the air cleaner assembly and air du ...
See also:
Rear Wheel Speed Sensor Removal
4WD only
1.
Remove the rear wheel and tire.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
...
Front Oil Seal Removal and Installation
1.
Remove the crankshaft damper pulley.
(Refer to Timing System - "Crankshaft Damper Pullty")
2.
Remove the front oil seal(A). ...
Description
The charging system included a battery, an alternator with a built-in
regulator, and the charging indicator light and wire.
The Alternator has eight built-in diodes, each rectifying AC curre ...