Kia Sorento: Installation
•
|
Install the component with the specified torques.
|
•
|
Note that internal damage may occur when the component
is dropped. If the component has been dropped, inspect before
installing.
|
|
•
|
Insert the sensor in the installation hole and be careful
not to damage.
|
|
1. |
Install in the reverse order of removal.
|
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Remove the rear seat.
(Refer to Body - "Rear ...
The GDI injector is similar to a standard injector, but sprays fuel at
a much higher pressure directly into the combustion chamber and has a swirl
disc to get the fuel swirling as it exits th ...
See also:
A/C Pressure Transducer Inspection
1.
Measure the pressure of high pressure line by measuring voltage
output between terminal “1” and “2”.
2.
Inspect the volt ...
Rear Coil Spring Removal
1.
Remove the rear wheel and tire (A) from rear hub .
Tightening torque :
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
...
Engine compartment
1. Engine coolant reservoir
2. Engine oil filler cap
3. Brake/clutch fluid reservoir
4. Air cleaner
5. Fuse box
6. Negative battery terminal
7. Positive battery terminal
8. Radiator cap
9. E ...