Kia Sorento: Installation
•
|
Install the component with the specified torques.
|
•
|
Note that internal damage may occur when the component
is dropped. If the component has been dropped, inspect before
installing.
|
|
•
|
Apply the engine oil to the O-ring.
|
|
•
|
Insert the sensor in the installation hole and be careful
not to damage.
|
|
1. |
Install in the reverse order of removal.
Crankshaft position sensor installation
bolt: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7
lb-ft)
Crankshaft position sensor protector
installation bolt (M6): 9.8 ~ 11.8 N.m (1.0 ~ 1.2
kgf.m, 7.2 ~ 8.7 lb-ft)
Crankshaft position sensor protector
installation bolt (M8): 18.6 ~ 23.5 N.m (1.9 ~
2.4 kgf.m, 13.7 ~ 17.4 lb-ft)
|
|
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the crankshaft position sensor connector (A).
...
Camshaft Position Sensor (CMPS) is a hall sensor and detects the camshaft
position by using a hall element.
It is related with Crankshaft Position Sensor (CKPS) and detects the piston
pos ...
See also:
Head Lamps Inspection
1.
Check-points upon head lamp failure (HID)
(1)
Check the battery voltage. (Low beam will be on when the
battery voltage above 9V.) ...
Direct Electro Hydraulic Actuator Coupling Operation
Electronic Coupling
[Inactive]
[Active]
Operation Order
1.
4WD ECU receives CAN signals from the vehicle's sensors.
...
Checking the parking brake
Type A
Check whether the stroke is within specification when the parking brake pedal
is depressed with 66 lb, 294 N (30 kg) of force. Also, the parking brake alone should
securely hold the vehicl ...