1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the VIS valve connector.
|
3. |
Measure resistance between VIS valve terminals 1 and 2.
|
Rear Stabilizer Bar Removal
1.
Remove the rear wheel and tire (A) from rear hub .
Tightening torque :
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
...
TJ Joint Removal
•
Special grease must be applied to the driveshaft joint.
Do not substitute with anoth ...
Tire sidewall labeling
This information identifies and describes the fundamental characteristics of
the tire and also provides the tire identification number (TIN) for safety standard
certification. The TIN can be used ...