1. |
Connect the GDS on the Data Link Connector (DLC).
|
2. |
Turn the ignition switch ON.
|
3. |
Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.
|
Maintenance service
You should exercise the utmost care to prevent damage to your vehicle and injury
to yourself whenever performing any maintenance or inspection procedures.
Should you have any doubts concerning the i ...
SRS Control Module (SRSCM) Removal
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning ...
Inspection
1.
Remove the cowl top cover.
(Refer to the wiper)
2.
Disconnect the windshield deicer connector (A) from the wiper
motor linkage.
...