1. |
Connect the GDS on the Data Link Connector (DLC).
|
2. |
Start the engine and measure the output voltage of TPS 1 and 2
at C.T. and W.O.T.
|
3. |
Turn the ignition switch OFF and disconnect the scantool from
the DLC.
|
4. |
Disconnect the ETC module connector and measure the resistance
between the ETC module terminals 1 and 2.
|
1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the ETC module connector.
|
3. |
Measure resistance between the ETC module terminals 3 and 6.
|
4. |
Check that the resistance is within the specification.
|
Overhead Console Lamp Inspection
Remove the overhead console lamp assembly then check for continuity between
terminals. If the continuity is not as specified, replace the map lamp switch.
...
Special Service Tools
Tool(Number and Name)
Illustration
Use
09581-11000
Piston expander
Spreading the front disc brake piston.
...
Special Service Tools
Tool(Number and Name)
Illustration
Use
Deployment tool
0957A-34100A
Airbag deployment tool.
Deployment adapter
0957A-38510
...