1. |
Disconnect the ignition switch connector (B) and key warning switch
connector (A) from under the steering column.
|
2. |
Check for continuity between the terminals.
|
3. |
If continuity is not specified, replace the switch.
|
Steering Column and Shaft Inspection
1.
Check the steering column for damage and deformation.
2.
Check the joint bearing for damage and wear.
3.
Che ...
Propeller Shaft Removal and Installation
1.
After making a match mark on the flange yoke and transfer companion,
remove the propeller shaft mounting bolts (A).
Tightening torque:
...
Front Wheel Transfer Assembly Removal
It is not recommended to overhaul the transfer assembly because
a special three-dimensional measuring instrument is requ ...