Kia Sorento: In-car Sensor Replacement
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / In-car Sensor Replacement
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Using a screwdriver or remover, remove the center fascia panel
(A).
|
| 3. |
Disconnect the clock connector (A).
|
| 4. |
Disconnect the heater and A/C controller connectors (A).
|
| 5. |
Loosen the mounting 2 screws and then remove the in-car sensor
(A).
|
| 6. |
Install in the reverse order of removal.
|
In-car Sensor Inspection
1.
Turn the ignition switch ON.
2.
Blow air with changing temperature into the in-car sensor air
inlet. Measure the sensor resistance betwe ...
Photo Sensor Description
The photo sensor is located at the center of the defrost nozzles.
The photo sensor contains a photovoltaic (sensitive to sunlight) diode.
The solar radiation received by its light receiving ...
See also:
Transaxle Control Module (TCM) Installation
When replacing the TCM, the vehicle equipped with the immobilizer
must be performed procedure as below.
[In the ...
Telemetics Unit (TMU) Component
Connector Pin Specification
No.
Pin Name
Type
From
To
Description (Wiring Spec.)
1
GND
DC Ground
TMU
Battery
...
Engine Control Module (ECM) Installation
1.
Install in the reverse order of removal.
ECM installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m,7.2 ~ 8.7 lb-ft)
ECM ...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026