Kia Optima Manuals

Kia Sorento: In-car Sensor Inspection - Air conditioning System - Heating,Ventilation And Air Conditioning - Kia Sorento XM 2011-2026 Service ManualKia Sorento: In-car Sensor Inspection

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / In-car Sensor Inspection

1.
Turn the ignition switch ON.
2.
Blow air with changing temperature into the in-car sensor air inlet. Measure the sensor resistance between 1 and 2 terminals.

1. Incar Motor(-)
2. Sensor Ground
3. -
 4. Incar Sensor (+)
5. -
6. IGN2 (Motor (+))

Specification
Temperature [°C(°F)]
 Resistance between terminals 2 and 4 (kΩ)
0 (32)
 97.71 ± 2.61%
15(59)
 47.12 ± 1.45%
25(77)
 30.00 ± 1.2%
35(95)
 19.60 ± 1.44%
50(122)
 10.82 ± 2.26%

  
An in-car sensor is a negative type thermistor. The resistance will rise with lower temperature, and reduce with higher temperature.
In-car Sensor (DATC only) Description
An in-car air temperature sensor is located in the crash pad lower panel. The sensor contains a thermistor which measures the temperature of the inside. The signal decided by the resistance ...

In-car Sensor Replacement
1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remover, remove the center fascia panel (A). ...

See also:

Side Impact Sensor (SIS) Components
...

Brake Line Removal
1. Disconnect the brake fiuid level switch connector, and remove the reservoir cap. 2. Remove the brake fluid from the master cylinder rese ...

Rear Wiper Motor Inspection
Rear Wiper Motor 1. Remove the 4P connector from the rear wiper motor. 2. Connect battery positive (+) and negative (-) cables to terminals ...

Categories

Copyright www.ksmanual.com 2014-2026