1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the crash pad lower panel (A).
(Refer to Body - "Crash pad")
|
3. |
Disconnect the 5P connector of the SMARTRA unit and then remove
the SMARTRA unit (A) after loosening a bolt.
|
Auto Light Sensor Installation
1.
Reconnect the auto light connector.
2.
Install the auto light sensor.
...
Front Bumper Replacement
•
Pry the trim off using a plastic trim tool and apply protective
tape around the rela ...
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification:
Refer to “Wave Form”
...