If engine doesn't turn over or turns over slowly
1.If your vehicle has an automatic transaxle, be sure the shift lever is in N (Neutral) or P (Park) and the emergency brake is set.
2.Check the battery connections to be sure they are clean and tight.
3.Turn on the interior light. If the light dims or goes out when you operate the starter, the battery is discharged.
4.Check the starter connections to be sure they are securely tightened.
5.Do not push or pull the vehicle to start it. See instructions for "Jump starting".
WARNING
If the engine will not start, do not push or pull the vehicle to start it. This could result in a collision or cause other damage. In addition, push or pull starting may cause the catalytic converter to overload and create a fire hazard.
If engine turns over normally but does not start
1.Check the fuel level.
2.With the ignition switch in the LOCK position, check all connectors at the ignition coils and spark plugs. Reconnect any that may be disconnected or loose.
3.Check the fuel line in the engine compartment.
4.If the engine still does not start, call an authorized Kia dealer or seek other qualified assistance.
Front seat adjustment - power (if equipped)
The front seat can be adjusted by using the control switches located on the outside
of the seat cushion.
Before driving, adjust the seat to the proper position so you can easily control
the steerin ...
Components
1. HECU module
2. Front wheel speed sensor
3. Rear wheel speed sensor
4. Yaw rate & Lateral G sensor
5. ABS Warning lamp
6. Parking brake/EBD warning lamp
7. ESC F ...
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the connector (A), and then remove the sensor ...