In case of removing the high pressure fuel pump, high pressure
fuel pipe, delivery pipe, and injector, there may be injury caused by
leakage of the high pressure fuel. So don’t do any repair work right
after engine stops.
|
1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Release the residual pressure in fuel line.
(Refer to the Fuel Delivery System - Repair Procedures - "Release
Residual Pressure in Fuel Line")
|
3. |
Remove the air cleaner and the air intake hose
(Refer to Engine Mechanical System - “Intake And Exhaust System”)
|
4. |
Disconnect the fuel pressure control valve connector (A).
|
5. |
Remove the ignition coil (B).
|
6. |
Disconnect the fuel feed tube quick-connector (A).
|
7. |
Remove the high pressure fuel pipe.
|
8. |
Remove the installation bolts (E), and then remove the high pressure
fuel pump from the cylinder head assembly.
|
In-car Sensor Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remover, remove the center fascia panel
(A).
...
Rear Glass Defogger Switch Inspection
1.
It will be able to diagnose defects of rear glass defogger with
GDS quickly. GDS can operates actuator forcefully, input/output value
monitoring and self diagnosis. ...
Exhaust Manifold Components
1. Heat protector
2. Exhaust manifold
3. Exhaust manifold gasket
4. Exhaust manifold stay
...