1. |
Turn the head lamp switch off.
|
2. |
Disconnect the power connector from the lamp.
|
3. |
Remove the lamp assembly.
|
4. |
Remove the dust cover.
|
5. |
Remove the ignitor clip (A) from the lamp assembly.
|
6. |
Disconnect the ignitor connector.
|
7. |
Remove the ignitor and bulb (A).
|
8. |
Installation is the reverse of removal.
|
1. |
Turn the head lamp switch off.
|
2. |
Disconnect the power connector from the lamp.
|
3. |
Remove the lamp assembly
|
4. |
Remove the dust cover.
|
5. |
Turn the bulb socket (A) counterclockwise and then remove it.
|
6. |
Remove the bulb (A) from socket.
|
7. |
Installation is the reverse of removal.
|
1. |
Turn the head lamp switch off.
|
2. |
Remove the lamp assembly
|
3. |
Turn the bulb socket (A) counterclockwise and then remove the
turn signal lamp bulb (B).
|
1. |
Turn the head lamp switch off.
|
2. |
Disconnect the power connector from the lamp.
|
3. |
Remove the head lamp assembly.
|
4. |
Remove the ballast (A) after loosening the screws (4EA).
|
5. |
Installation is the reverse of removal.
|
TPMS Receiver Operation
1.
General Function
A.
Auto learn takes place only once per Ignition cycle.
B.
On successful compl ...
Interior D
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
Front pillar ...
Photo Sensor Replacement
1.
Disconnect the negative (-) battery terminal.
2.
With a flat-head screwdriver, remove the photo sensor (A) from
the center of the defros ...