1. |
Release the residual pressure in fuel line.
(Refer to the Fuel Delivery System - Repair Procedures - "Release
Residual Pressure in Fuel Line")
|
2. |
Remove the rear seat assembly.
(Refer to Body - “Rear Seat Assembly")
|
3. |
Remove the fuel pump service cover (A).
|
4. |
Disconnect the fuel pump connector (A) and the fuel tank pressure
sensor connector (B).
|
5. |
Disconnect the fuel feed tube quick connector (C).
|
6. |
Remove the rear - LH wheel & tire.
|
7. |
Lift the vehicle and support the fuel tank with a jack.
|
8. |
Remove the center & rear muffler assembly.
(Refer to Engine Mechanical System - “Muffler”) [4 WD]
|
9. |
Remove the propeller shaft.
(Refer to Driveshaft and axle - “Propeller Shaft”) [4WD]
|
10. |
Disconnect the fuel filler hose (A) and the ventilation tube quick-connector
(B).
|
11. |
Disconnect the ventilation tube quick-connector (A).
|
12. |
Disconnect the vapor tube quick-connector (B).
|
13. |
Remove the fuel tank (B) from the vehicle after removing the fuel
tank band (A).
|
Inspection
1.
Turn ignition switch OFF.
2.
Remove the air duct.
(Refer to Engine Mechanical System - "Air cleaner")
...
Auto Defogging Sensor Inspection
To inspect and diagnose the sensor, refer to Self-Diagnosis procedure
and DTC guide. ...
Engine start/stop button
Illuminated Engine Start/Stop button
Whenever the front door is opened, the ENGINE START/STOP button will illuminate
for your convenience.
The light will go off after about 30 seconds when the do ...