1. |
Remove the windshield wiper arm and blade after removing a nut
(B) and wiper cap (A).
|
2. |
Remove the windshield wiper arm and blade (A) after removing a
nut.
|
3. |
If necessary, release the wiper blade fixing clip by pulling up
and remove the wiper blade from the inside radius of wiper arm.
|
4. |
Remove the weather strip and the cowl top cover (A) after removing
retainers.
|
5. |
Disconnect the wiper motor connector (A) from the wiper motor
& linkage assembly.
|
6. |
Remove the windshield wiper motor and linkage assembly (A) after
removing 2 bolts.
|
7. |
Hold the wiper motor crank arm and remove the upper linkage (A)
from the wiper motor crank arm.
|
8. |
Remove the lower linkage (A) from the wiper motor crank arm.
|
9. |
Remove the crank arm (A) after loosening a nut.
|
10. |
Remove the wiper motor (A) after loosening the screws.
|
Canister Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Lift the vehicle.
3.
D ...
Pressure Sensor Description
The 4WD ECU makes a Motor Pump(Actuator) turn round for generating an
oil pressure. And then it presses a multiple disk clutch and transfers the generated
torque into rear wheels. Its torque ...
Cooling Fan Components
1. Upper air guard
2. Cooling fan control module
3. Cooling fan shroud
4. Fan motor
5. Cooling fan
...