It is not recommended to overhaul the transfer assembly because
a special three-dimensional measuring instrument is required to determine
the sizes of the transfer assembly spacers when disassembling and reassembling
the transfer assembly. If putting wrong sized spacers in the transfer
assembly, it may cause noise and vibration.So, if inner parts of the
transfer assembly need to be replaced, the transfer assembly should
be replaced with new one.
|
1. |
Remove the following items;
|
2. |
Remove the propeller shaft (A).
|
3. |
Loosen the transfer upper & lower mounting bolts. (transfer side
→ transaxle side)
|
4. |
Loosen the transfer lower mounting blot. (transaxle side → transfer
side)
|
Blower Resistor Inspection
1.
Measure the resistance between the terminals.
2.
The measured resistance is not within specification, the blower
resistor must be replac ...
IMS Power Seat Control Circuit Diagram
...
Rear Body
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
Side outer p ...