1. |
With the washer motor connected to the reservoir tank, fill the
reservoir tank with water.
|
2. |
Connect positive (+) battery cables to terminal 1 and negative
(-) battery cables to terminal 2 respectively.
|
3. |
Check that the motor operates normally and the washer motor runs
and water sprays from the front nozzles.
|
4. |
If they are abnormal, replace the washer motor.
[Front & Rear washer]
1. Windshield washer (+)
2. Ground
3. Rear washer (+)
|
1. |
Disconnect the negative(-) battery terminal.
|
2. |
Drain the washer fluid less than 650 cc.
|
3. |
Check for continuity between the No. 1 and No.2 terminal in each
float position.
There should be continuity when the float is down.
There should be no continuity when the float is up.
|
4. |
If the continuity is not as specified, replace the washer fluid
level switch
|
Removal
1.
Disconnect the battery negative cable from the battery and then
wait for at least 30 seconds.
2.
Turn the steering wheel so that the fr ...
AVN Head Unit Installation
1.
Connect the AVN head unit connectors and cable.
2.
Install the AVN head unit.
3.
Install the center air vent ...
Inspection
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the fuel pressure regulator valve connector.
...